Problems Completing the IAT

<

Where is my feedback?

Answer: If you just finished taking the study, you can access your feedback here.
When you get to the end of the study, the popup window will close and the results will display in the original window that launched the study (the page that said "See the green checkmark? Click Here to Begin.). Say yes if your browser asks if you want to allow the page to close the window. Once you close your browser or start another study, we have no way of accessing your results directly, for confidentiality reasons.

If you're still having troubles, please report the nature of your difficulties.


What type of browser will work in order to take the tests?

Answer: The following are the minimum system requirements:

  • Javascript must be enabled
  • Cookies must be enabled
  • Pop-up windows must be allowed
  • Flash Player Plugin (version 6.0 or higher) from Adobe is required in order to run the tests. If you're not sure what version of Flash you have installed, you can check here.

Linux users must have common system fonts installed.
WebTV is not supported at this time.
Mac users should not use Internet Explorer.

If you're still having troubles, please report the nature of your difficulties.


I can't access the tests. When I click on a test, there is a message that says an error has occurred. What should I do?

Answer: There may have been a network error. You may want to wait and try again.

If you're still having troubles, please report the nature of your difficulties.


I get an error message saying that my session has "timed out". What happened, and what should I do?

Answer: For security reasons, after about 15 minutes of inactivity, your session will expire. Unfortunately, you cannot continue the test where you left off, so if you'd like to complete the test, you'll have to start over.

If you're still having troubles, please report the nature of your difficulties.


I tried to take the IAT and all I saw was a blank screen -- no test. What's the problem?

Answer: Are you using Safari? If so, make sure that you are using version 1.2 or greater, or use Netscape, Firefox, or Opera instead. Also, the Flash Player Plugin version 6.0 or higher is required in order to take the test. Check here to see what version of Flash you have.

If you're still having troubles, please report the nature of your difficulties.


I tried to take the IAT and the program produced a red X and stopped. What's the problem?

Answer: When a word or picture is not classified into the appropriate category, a red X appears. Each word or picture has one and only one correct classification. For example, if you are sorting Old and Young faces and Good and Bad words. All of the Old faces are categorized with the key associated with 'Old', all of the Young faces with the key associated with 'Young', all of the Good words with the key associated with 'Good', and all of the Bad words with the key associated with 'Bad'. If you make an error in classification the program waits for you to make the other response from the one you originally made before it proceeds. If this happens for only a few items, the test may still be useful for you. Nevertheless, you will be obliged to give the response expected by the applet in order for the test to proceed.

If you're still having troubles, please report the nature of your difficulties.


When the test is complete, and I try to print the results, I get a message that reads "We are sorry, an error has occurred. Please try again later." This has happened on two different occasions. Could you help me figure out how to print the results?

Answer: Unfortunately, we don't have control over whether or not the page will print -- that is determined by the settings of your local computer. Here are a few suggestions:

  1. Try to save the page by going to File -> Save As and saving it as a local file. Then close Internet Explorer and try to open it again and print it.
  2. You can save the screen image and copy and paste it into Word, and then print it. To do this, hit the "Print Screen" key on your keyboard whenyour results are on the screen. Then, open a word processing program such as Microsoft Word. Hit CTRL+V to paste the image into a document. That should create a document that you can print.

If you're still having troubles, please report the nature of your difficulties.


I was only able to get halfway through the IATs and then it would lock up. What's wrong?

Answer: If at any time during the test you clicked outside of the test window (e.g., you responded to an IM or checked your email), then the application will lose focus, and the IAT will stop responding to and recording your keystrokes. In order to fix this, simply move your mouse over the black box in the middle of the screen (your cursor will disappear), and then left-click.

If you're still having troubles, please report the nature of your difficulties.

Project Implicit Services

Copyright © IAT Corp.